Special Safety Instructions - Hendi 271520 Mode D'emploi

• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.

Special safety instructions

• Avoid contacting moving parts. Never place fingers or anything other then ice into feed
or discharge areas.
• Do no use outdoors.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Check hopper for presence of foreign objects before using.
• Use only attachments that are included in the packaging of the Ice Crusher. The use of
other attachments may cause fire, electric shock or injury.
• Not suitable for continuous use.
Preparation before first use
EN
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance, see: Cleaning and mainte-
nance.
Operation
• Place the ice container (clear bowl) under the bot-
tom opening of the ice crusher.
NOTE: The ice crusher will not operate unless the
ice container and hopper are secured into position.
• To begin crushing ice, drop cubes into the hop-
per on top of the appliance and switch it on. The
blades of the crusher are self-feeding.
• WARNING: DON'T PUSH CUBES DOWN THE
CHUTE WITH YOUR HANDS OR OTHER TOOLS.
Cleaning and maintenance
• UNPLUG POWER CORD FORM OUTLET.
• The appliance should be cleaned after use, and
before use if it hasn't been used for a prolonged
period of time.
4
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• If a large cube becomes lodged in the crushing
unit so that blades cannot reach it, switch the
appliance OFF and unplug from the outlet. Pour
warm water down the hopper until lodged cube is
melted or comes loose. WARNING: Only use clear
ice.
• When the crushing is finished the container can
be removed (the removal of the container will stop
the machine). Turn the appliance off and unplug.
• Remove the ice container and the hopper and
clean these parts with warm water and if needed a
mild detergent, rinse thoroughly.