Mitsubishi Electric Mr.SLIM PKA-RP35HAL Manuel D'utilisation page 18

10. Care and Cleaning
■
PCA-RP·KAQ
Open the intake grille.
Hold the knob on the filter then pull the filter up in the direction of an arrow. To
replace the filter after cleaning, be sure to insert the filter far enough until it fits
into the stopper.
Filter r Intake Grille
■
PSA-RP·GA
•
Remove the screw from the suction grille handle.
•
The suction grille is open if you pull the handle in arrow direction
•
The filter is set inside the suction grille and is open if you pull it in arrow direction
Suction grille
Handle
Screw
18
Knob Stopper
.
■
PCA-RP·HAQ
RP71 → 3 pieces
RP125 → 4 pieces
►Cleaning the oil filter (PCA-RP·HAQ Series)
1) Removing the oil filter
Remove the filter by sliding it in the direction of an arrow.
2) Replacing the filter element
Remove the oil filter by sliding it in the direction of an arrow.
Remove the two metal fittings for filter element according to the following proce-
dure. Bend the metal fittings towards
direction of to remove.
Replace the filter element (disposable).
Optional parts: PAC-SG38KF (12 pieces)
Note:
Install the filter element within the frame securely.
Install the metal fittings for filter element in their original positions.
Turn the side of oil filter that the metal fittings are installed downward and install
the filter in the unit.
Handle
Oil filter
3) Cleaning the frame of the oil filter
Tools to be prepared
• Protective goods such as a rubber glove
• Scrubbing brush or brush
Note:
Avoid using a metal scrubbing brush or brush since the aluminum materials
could be damaged.
• Household neutral detergent or alkalescent detergent (for washing dishes or
clothes)
Note:
If alkaline detergent is used for cleaning, the part made of aluminum could
discolor.
Note:
Make sure the filter element is removed when cleaning the oil filter.
If the filter is not so dirty. (If the filter is cleaned once a week (once per 100 oper-
.
ating hours).)
Wash the filter with water and above-mentioned detergent using a scrubbing brush
or brush, etc. (It is more effective to wash the filter with lukewarm water.)
If the filter is extremely dirty.
Put the previously-mentioned detergent (its strength should be about 1/10 of un-
diluted solution) into hot water whose temperature is 50 °C or less, and soak the
filter for 1 hour or more before washing.
Warning:
To prevent your hand from burning, start washing the filter after the hot water
gets cold.
side (inside) and then slide them in the
Filter element
Metal fitting for filter element