Using The Remote Control - Samson Resolv RXA10S Mode D'emploi

Using the Remote Control

You can take advantage of many of the features of the
RXA10S using the infrared remote. Make sure that
the battery (LR2032) is installed and then follow the
sections below that detail the operation of the remote
control.
SYSTEM MUTE button
The SYSTEM MUTE button is used to turn off the entire
monitor system including the sub woofer and satellite
speakers. Aim the remote control at the RXA10S and
press SYSTEM MUTE. When you want to get back to
listening, press the SYSTEM MUTE button again to
unmute the system.
STANDBY Button
The STANDBY button puts the subwoofer to sleep. This
is useful when you are no longer using the subwoofer.
The subwoofer has an signal sensing circuit that takes
the speaker out of the standby mode when it senses
and audio signal. To put the subwoofer in the standby
mode, aim the remote at the RXA10S and press the
STANDBY button.
SUBWOOFER volume controls
The SUBWOOFER +/- controls are used to adjust the level of the subwoofer. To
adjust the volume of the subwoofer, aim the remote control at the RXA10S and press
the SUBWOOFER + or - button.
SUB MUTE button
Once you have a good listening level set for the monitor system you can audition
your mix with and without the subwoofer by using the SUB MUTE button. Point
the remote control at the RXA10S and press SUB MUTE to mute or unmute the
subwoofer. Thanks to the RXA10S intelligent crossover design, the outputs to the
satellite speakers are returned to full range when the subwoofer is muted using the
SUB MUTE button. When you unmute the subwoofer by pressing the SUB MUTE
button again, the outputs to the satellite speakers are once again passed at the
crossover point set by the rear panel FREQUENCY control knob.
SYSTEM Volume controls
The SYSTEM +/- controls are used to adjust the overall level of the monitor
system, which includes the RXA10S and the connected satellite speakers. To
adjust the volume of the speaker system, aim the remote control at the RXA10S and
press the SYSTEM + or - button.
DIM control
The DIM feature let's you instantaneously lower your mix by 20dB. It is useful for
checking your mix at low levels, a practice engineers utilize to hear where things are
sitting in the mix. Aim the remote control at the subwoofer and press SYSTEM DIM
and the level will be lowered by 20dB. When you want to get back to the normal
listening level, press the SYSTEM DIM button again.
8