Grinder Assembly - Weston 36-0801-W Mode D'emploi

GRINDER ASSEMBLY

1. A. If you are using a clamp down #8 or #10 Grinder, slide the Protector Pad
onto the foot of the Grinder and tighten the Clamp Screw to secure the Grinder
to the work surface. Allow ample room for the Handle to rotate.
B. If you are using a bolt down #22 or #32 Grinder, the body of the Grinder
can be attached to a solid work surface using appropriately sized screws (not
provided). Allow ample room for the Handle to rotate.
FIGURE 1
2. Insert the Auger Bearing into
Auger
the Grinder Body through the
Bearing
hole in the back of the Grinder.
FIGURE 1
Auger
Knife
3. Insert the Auger into the
Grinder Body. Rotate the Auger
Grinder
while inserting to fully seat the
Body
Auger
Auger into the Grinder Body.
Notch
Pin
Plate
4. Slide the Knife over the
Front
square portion of the Auger Pin
Ring
on the front of the Auger, making
Nut
sure the cutting edges of the
Knife are facing outward.
FIGURE 2
5. Slide the Plate of choice over
Handle
the round portion of the Auger
Pin. Align the notch on the Plate
with the notch in the Grinder Thumbscrew
Body so that the Plate fully sits in
the opening of the Grinder Body.
6. Snugly screw on the Front Ring Nut. DO
NOT OVER TIGHTEN! If the Front Ring
Nut is screwed onto the Grinder Body too
tightly, the Auger will be hard to turn/will
not turn.
7. Slide the Handle over the exposed end
of the Auger and lock it in place with the
Thumbscrew. FIGURE 2
7