Daewoo DI-40HVF-3P2 Mode D'emploi page 5

Loosen the nut (5) of the motor (8). Firmly mount
the rear grille (6) on the motor by matching 3
mounting pads. Tighten the nut (5) on the back
grid so as to block the grill against the motor.
Mount the fan blades (4) on the axis (7). Firmly
secure them with the reversed nut (3). At this
point, the blades should turn freely without
touching the nut of the rear grille.
Loosen the locking strapping clip (2a) Put the
front grille on the rear grille and tighten the
locking screw.
USE AS TABLE FAN
Put (12) into the hole of (11)
and tighten with (10),
Insert the fan body (8) in (12) and tighten the screw to secure the
connection tube. Rest steps same as stand fan.
USE AS WALL FAN
Mounting (9) on to the wall then Insert the fan body (8) in (9) and
tighten the screw to secure the connection tube. Rest steps same as
stand fan.
then
GB-5