Replacing Bulb - FAR HD500X-15M Manuel D'utilisation

Alu.Filter
Installing the charcoal filter (see Pic. 9,10)
Remove the filters see Pic.9.
1.
The charcoal filters (Pic.10) are located at both end of the motor. Turn the charcoal
2.
filters until they are unscrewed.
Uninstall the charcoal filter according to pic.10.
3.
Warning: the charcoal filer cannot be washed or recycled.
It should be replaced after approximately 2-3 months of use.
Remark: Charcoal filter is not supplied with your appliance.

REPLACING BULB

Before replacing the bulb, make sure that the appliance is plugged off.
1.
Remove the grease filters, uninstall the light panel by a screwdriver, then unplug the
2.
light plug, see pic.11.
Push the fixing spring to take out the light assembly and replace a new bulb
3.
(12V - 20W G4 type), then install the light assembly and light panel, see pic.12.
Pic.11
Close
Open
Pic.9
Open
Close
Pic.10
Light plug
Pic.12
ENGLISH
GB-11