FAR HD500X-15M Manuel D'utilisation page 23

5 × 10 holes
5 × wall
Interior chimney
5 × large
plugs
bracket
screws
Hook
Pic.2
Safty
screw
Pic.5
Notice of Installation
• Any installation work must be carried out by a qualified electrician or competent
person.
• Do not connect the ducting system of the hood to any existing ventilation system
which is being used for any other appliance. Such as warmer tube, gas tube, and
hot wind tube.
• The angle of the bend of the ventilation pipe should not be less than 120°; you
must direct the pipe horizontally or alternatively, the pipe should go up from the
initial point and should be led to an outer wall.
• After the installation, make sure that the cooker hood is level to avoid grease
collection at on end. See Fig.8.
Right
Extensible
tube
Pic.3
2 × small
screws
Pic.6
Wrong
Pic.4
2 × small
screws
Pic.7
Pic.8
ENGLISH
GB-9