Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
your finger on the on/off switch or connecting
the tool to the mains supply with the switch
in 'ON' position, this may result in accidents.
• Remove any adjusting key or wrench be-
fore turning the tool on. A wrench or a key
that is left attached to a rotating part of the
power tool may result in personal injury.
• Do not overreach. Keep proper footing and
balance at all times. This enables better con-
trol of the power tool in unexpected situations.
• Dress properly. Do not wear loose cloth-
ing or jewellery. Keep your hair, clothing
and gloves away from moving parts. Loose
clothes, jewellery or long hair can be caught
in moving parts.
• If devices are provided for the connection
of dust extraction and collection facili-
ties ensure that these are connected and
properly used. Use of these devices can
reduce dust-related hazards.
Power tool use and care
• Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better and
safer at the rate for which it was designed.
• Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
• Pull the mains plug and/or remove the
battery before adjusting a tool, changing
accessories or putting the tool aside. This
precaution avoids the unintentional start of
the tool.
• Store idle power tools out of the reach
of children and do not allow persons
Unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check for misalign-
ment or binding of moving parts, breakage of
parts and any other condition that may affect
the power tool's operation. If damaged, have
the power tool repaired before use, Many
accidents are caused by poorly maintained
power tools.
• Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner intended
GB | Operating Instructions
for the particular type of power tool, tak-
ing into account the working conditions
and the work to be performed. Use of the
power tool for operations different from in-
tended could result in a hazardous situation.
Appropriate handling and use of battery-
operated power tools
• Make sure that the device has been
switched off before inserting the battery.
Inserting a battery into a switched-on power
tool may lead to accidents!
• Only use charging devices recommended
by the manufacturer to charge the batter-
ies. Charging units are usually designed for
certain types of batteries; if used with other
types there is a risk of fire!
• Only use batteries designed for your
power tool. The use of other batteries may
lead to injury and risk of fire!
• Keep unused batteries clear of paper
clips, coins, keys, nails, screws or other
small metal objects that may bridge the
contacts. A short circuit between the battery
contacts may lead to burns or fire!
• Improper use may result in fluid leaking
out of the battery. Avoid any contact with
battery fluid. Flush with water in case of
contact. If battery fluid should get into
your eyes seek medical advice addition-
ally. Leaking battery fluid may lead to irrita-
tions of the skin or burns!
Service
• Have your power tool serviced by a quali-
fied repair personnel using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Safety instructions for the charger
and rechargeable battery
the scope of delivery)
• Read the guidelines and safety information
• Only use the prescribed charger to charge the
• Do not charge any other rechargeable bat-
GB-3
before charging the rechargeable battery.
rechargeable battery.
teries with this charger. Only use the charger
together with the corresponding rechargeable
battery.
(not included in
Publicité
Chapitres
Table des Matières
