Title Assignment - JVC KD-G722 Manuel D'instructions

Indications
TAG DISP
Tag display
AMP GAIN
Amplifier gain control
IF BAND
Intermediate frequency
filter

Title assignment

You can assign titles to CDs (both in the unit
and the CD changer). You can assign up to 30
discs and each title up to 32 characters.
• You cannot assign a title to a CD Text, an
MP3/WMA disc, or a USB memory.
1
Select the sources.
• For CDs in this unit: Insert a CD.
• For CDs in the CD changer: Select
"CD-CH," then select a disc number.
2
Enter the title assignment mode.
Ex.: When "CD" is selected as the source
3
Assign a title.
1 Select a character.
18
Selectable settings, [reference page]
TAG ON : [Initial]; Shows the Tag information while playing MP3/
WMA tracks, [14].
TAG OFF : Cancels.
You can change the maximum volume level of this unit.
LOW PWR : VOL 00 – VOL 30 (Select this if the maximum power of
the speaker is less than 50 W to prevent them from being
damaged.)
HIGH PWR : [Initial]; VOL 00 – VOL 50
AUTO : [Initial]; Increases the tuner selectivity to reduce
interference noises between close stations. (Stereo effect
may be lost.)
WIDE : Subject to interference noises from adjacent stations, but
sound quality will not be degraded and the stereo effect
will remain.
2 Move to the next (or previous)
character position.
3 1
Repeat steps
finish entering the title.
4
Finish the procedure.
To erase the entire title
In step 2 on the left...
Available characters
2
and until you