Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION CONT.
3.
Attach bottom part of rear bracket using one 5/16 - 18
hex lock nut (C1), one 5/16 flat washer (C2) and one
5/16 - 18 x .75 hex head bolt (C3). See Figure 4.
Note:
Due to the factory frame, it may be
necessary to drill a 5/16" clearance hole on
one side to attach the rear bracket.
4.
Attach bottom of front bracket to frame using two 5/16
- 18 hex lock nuts (C1), two 5/16 flat washers (C2) and
two 5/16 - 18 x .75 hex head bolts (C3).
Note:
Due to the factory frame, it may be
necessary to drill a 5/16" clearance hole in
one or both holes of front bracket to attach
properly.
5.
Repeat steps one through four for other side.
6.
Torque all bolts starting with factory bolts to torque
specifications on page 2.
7.
See Figure 6 for completed view of driver side.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
PAGE 4
Figure 4
Figure 5
Figure 6
76599A0
Publicité
Table des Matières
