Fm Mode Operation; Aux-In Mode Operation - 1byone OUK00-0860 Manuel D'instructions

Note:
DRC only works if it is enabled by the broadcaster for a specific station.
To change the DRC setting
Select Menu > DRC, then press ENTER button
to enter the DRC submenu.
Press "<" or ">" to select the available options:
DRC off, high, low.
DRC off: DRC is switched off.
DRC high: DRC is switched on; the default setting recommended for noisy
environments.
DRC low: DRC is set to half level.

FM MODE OPERATION

FM radio mode receives analogue radio from the FM band (87.5-108MHz)
and display RDS (Radio Data System) information about the station.
1. Fully extend the telescopic antenna.
2. Rotate the FUNCTION Selector to FM position to
enter FM mode.
3. Press and hold the "<" or ">" button to search the
station. It will then stop automatically at the first
station it finds.
4. Short press "<" or ">" button to tune the radio down or up in 50KHz steps
for fine tuning.
Note:
If reception is too weak and there is noise on the received station, try to
improve the reception by changing the position of the telescopic antenna.
15
Station presets
The unit allows you to store up to 20 FM stations which work in the same way
as described in DAB mode.
Now playing information
While FM radio is playing, the screen shows its frequency,
or any further 'RadioText' information.
If no information is available, just the frequency and a No
Radio Text message is shown.
To view further information about the broadcast
Each time you press INFO button, the next set of
information is displayed, cycling through: RDS
RadioText, programme type, frequency, time and date.

AUX-IN MODE OPERATION

AUX-IN mode plays audio from an external source such as an MP3 player.
1. Plug one end of the 3.5mm audio cable (included) into the headphone or
line out jack on your player. Plug the other end of cable into the unit
AUX-IN jack on the back of the unit.
2. Rotate the FUNCTION Selector to AUX position to enter AUX mode.
3. Turn on the external audio source and play your device.
4. Control the volume level and operate all other functions on the external
device as usual.
Notes:
1. If your external device is connected to the line out jack, then you only
need to adjust the volume control of this unit. If your external device is
connected to the headphone jack, then you may need to adjust both the
volume control of your external device and the volume control of this unit
to find the most desirable volume setting.
16