General Operation; Setting The Language; Setting The Clock Time And Date; Sleep Timer Setup - 1byone OUK00-0860 Manuel D'instructions

Notes:
1. The duration of the charging process depends on the state of charge of the
battery.
2. Remember to take out the battery during longer periods of non-use.

GENERAL OPERATION

1. Rotate the Power ON/OFF Switch to "ON" position to turn on the unit. The
display will light up and display the time digits and the current operating
mode.
2. Rotate the Function Selector to select different operating modes: DAB, FM,
AUX-IN, or Bluetooth.
3. Press and hold /OK/STANDBY button for 3 seconds to enter into Standby
mode.
4. In Standby mode, press and hold
switch the unit on.
5. To completely switch off the unit, rotate the Power ON/OFF switch to OFF
position.
Note:
The unit will automatically switch to Standby mode if none of the main
functions of any operating modes have been actively used for 60 minutes
(except for FM mode).

Setting the language

The default language is English. To change the language, please follow the
steps below:
1. Press "Menu" button.
2. Press "<" or ">" button to select "System".
3. Press /OK button to enter the "System"
subdirectory.
4. Press "<" or ">" button to select "Language".
7
/OK/STANDBY button for 3 seconds to
5. Press /OK button to enter the "Language" subdirectory.
6. The language used for display messages can be selected from:
English/Francais/Deutsch/Italiano/Español
7. Press "<" or ">" button to select and press
language.

Setting the clock time and date

The time and date can be updated automatically. With auto-update, the time
and date are automatically synchronized with national time signals broadcast
over DAB and FM (when available).
The clock time can also be set manually. Please follow the steps below:
1. Press "Menu" button.
2. Press "<" or ">" button to select "System".
3. Press /OK button to enter the "System" subdirectory.
4. Press "<" or ">" button to select "Time".
5. Press /OK button to enter the "Time" settings
subdirectory. "Set Time/Date" will be shown on the
display. Press /OK button again to confirm and enter
into clock time settings.
6. Select a value for each parameter by using "<" or ">" button and then
press /OK button to confirm and move on to the next parameter.
7. "Time Saved" will be shown on the display once the date has been set.

Sleep timer setup

Sleep timer will turn the unit to standby mode automatically after the sleep
time you set.
1. Press "Menu" button.
2. Press "<" or ">" button to select "System".
3. Press /OK button to enter the subdirectory of "System".
/OK button to confirm the
8