Yakima 1033307 Mode D'emploi

WARNING!
This product is not intended
to be used as bow/stern tie-
down, paddle carrier, or load
strap. It is designed to be
used as a locking security
device only. Load demand on
this product can result in
property damage, personal
injury, or death.
SECURE THE LOOP END to
the kayak security bar, or
between seat and hull.
Close cuffs onto
paddles
between the
drip guard and
the blade.
PASS THE CABLE AROUND YOUR RACK.
The lock can be pulled off the cable
and repositioned as needed.
Insert the pin into
the lock and lock it.
1033307B - 1/2
BoatLocker
Thread the
cable through
the cuffs.
Position the lock
between the
cuffs.
Use a single
cuff for one-
piece paddles.
This product is covered by YAKIMA's
"Love It Till You Leave It" Limited Lifetime Warranty
To obtain a copy of this warranty, go online to www.yakima.com
or email us at yakwarranty@yakima.com or call (888) 925-4621
CUFF
PIN
VERIFY THAT THE PIN IS SECURE BY THE
PULLING ON THE LOCKED CABLE.
• Some larger paddles may require
the cuff to be located differently.
• Keep cuffs, lock and pin, free of
sand and dirt.
• Lubricate lock with a lock
lubricant.
• Replacement parts:
(888) 925-4621.
LOCK
(two-piece
paddle shown)
Part #1033307 Rev.B