Installing The Intelliflow ® Wall Box Unit (A2C-Sc-Wb) - Watts IntelliFlow A2C-SC Instructions D'installation

Installing the IntelliFlow
WARNING
!
Power MUST be off during installation or servicing of the valve!
Do not plug valve into supply circuit until completion of assembly.
NOTICE
For Vertical Installation Only!
1. Shut off electrical power supply to the electrical receptacle to be used with the IntelliFlow.
2. Shut off both hot and cold water supply lines.
3. Remove trim plate (Fig. Nos. 5 & 6) and set aside until you've completed wall finishing
(painting, wall papering, paneling, etc.).
Trim Plate
Figure 5
(side view)
4. Install the four mounting tabs provided in slots on the sides of the wall box enclosure
(Fig. No. 7).
5. Position the A2C-SC-WB between the wall studs as shown in Fig. No. 7. Check that it
is level and fasten the mounting tabs to the studs.
6. Remove drain plug knock out. Install drain piping and water supply piping to the appro-
priate IntelliFlow connection. Either IntelliFlow connection may be used for the hot or
cold water supply.
Finished
Wall
Mounting
Tabs (4)
IS-A2C-SC-IntelliFlow 2122
Wall Box Unit (A2C-SC-WB)
®
Wall Box
Water supply connections
16" on center – Typical
LISTED
3P47
U L
R
Trim Plate
Mounting
Drain
Slots (4)
Figure 7
(top view)
Trim Plate
Drain connection
Figure 6
(front view)
Wall
Studding
Drain
Knockout
© 2021 Watts
9