Installing The Thermostat - Honeywell TH115-AF-GA Guide Du Propriétaire

400-115-051-EFS

Installing the thermostat

Faceplate
Turn the heating system off at the main electrical panel.
Loosen the bottom screw and remove the thermostat faceplate from its
wallplate. (The screw cannot be completely removed.)
Connect the thermostat to the load and to the power supply (see page 7).
Connect the floor sensor (see page 8).
If you wish to connect a remote control device, see page 8.
Install the wallplate to the electrical box using the provided screws.
Set the configuration switches on the back of the faceplate (see page 9).
Wallplate
Install the faceplate back on the wall plate and tighten the screw.
Apply power to the heating system.
Test the ground fault protection (see page 19).
6