Edit The Default Programs - Vollrath MPI4-1800S Manuel D'utilisation

EDIT THE DEFAULT PROGRAMS

The factory-set programs can be edited. Use a computer to access the
program editor on the USB flash drive. Then load the new programs
into the induction range. One USB flash drive can be used to program
multiple induction ranges.
Load the Program Editor
1. Remove the USB flash drive from the induction range. Insert it into
the USB port on your computer.
2. Open the Programs folder.
3. Double click the Programs Editor file.
Edit Programs
1. Enter data for up to four programs. Each program can have up to
three stages.
A
B
A Programs B Stages
Medium Power Countertop Induction Ranges with Temperature Control Probe Operator's Manual
2. For each stage in the program:
Step 1 Step 2
Select
One Enter Select One
Power level
or temp
(°C or °F)
*Time can be entered in full and half minutes. To enter a half minute,
type .5. For example for five and one half minutes, type 5.5.
3. To edit another program, click the program tab.
4. Enter data for each program you wish to create.
5. To save the programs, click the Generate File button.
6. When you see the message at the bottom of the program editor
window, remove and then re-insert the flash drive.
7. The programs are saved to the USB when you see this message
and the programs.txt appears on the file list.
8. The edited programs are now ready to be transferred to the
induction range.
Optional
Enter Add Stages.
Time Select
Minutes*
Skip
7