Maintenance And Service; Disposal Information - Uzin Utz WOLFF NEO 400 Mode D'emploi Original

5.0 Ending the work
► After ending the work and when leaving the
machine, the mains plug-in must always be
removed from the power outlet.

6.0 Maintenance and Service

Maintenance and Cleaning
► Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
► Clean the cooling fins of the motor and electronic
system on a regular basis.
Once work has been completed, the clamping devices
must be disassembled and the machine cleaned
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for WOLFF power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article number
specified on the type plate of the machine.
Bodenschleifmaschine NEO 400, #76970
08/2015
7.0 Troubleshooting
Trouble Eventual cause
Machine does Imbalance
not run smoothly
Machine does Power supply
not start disconnected
blown fuse
defective cable or plug
Emergency stop locked
Machine overloaded
Machine switches off Machine overloaded
during work

8.0 Disposal information

Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its implementation into
national right, power tools that are no longer usable
must be collected separately and disposed
of in an environmentally correct manner.
Subject to change without notice.
Elimination
The segments have not been
distributed evenly over the
segment disc
Have machine
repaired by a qualified
electrician,
resp. change parts
Unlock by turning to right
Tilt the machine over the
transportation wheels.
The plate is unloaded.
slowly on the floor
additional weights
Remove,
After work, with red LED:
Wait until the motor has cooled
down, apply more diamond
segments if required to reduce
the sanding pressure, and
remove additional weights if
required
22