g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions and
the work to be performed.
Use of the power tool for operations different from
those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
2.2 Machine-specific Safety Warnings
Safety warnings for grinding machine
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
► Do not use damaged tools. Before each use,
inspect the tools for chips and cracks. If
the power tool or wheel is dropped, inspect for
damage or install an undamaged tool.
After inspecting and installing the tool, position
yourself and bystanders away from the plane of
the rotating wheel and run the power tool at
maximum no load speed for one minute.
Damaged tools will normally break apart during
this test time.
► Wear personal protective equipment. Depending
on the application, use a face shield, safety
goggles or safety glasses. As appropriate, wear
a dust mask, hearing protection and gloves.
The eye protection must be capable of stopping
flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating
Bodenschleifmaschine NEO 400, #76970
08/2015
particles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing
loss.
► Keep bystanders a safe distance away from the
work area. Anyone entering the work area must
wear personal protective equipment.
Fragments of workpieces or of a broken accessory
may fly away and cause injury beyond immediate
area of operation.
► Position the cord clear of the spinning accessory.
If you lose control of the power tool, the cord may
be cut or snagged and your hand or arm may be
pulled into the spinning accessory.
► Be aware of metal objects in the substrate.
If the flooring contains metal parts, these must be
removed before sanding.
18