Dust Extraction - Uzin Utz WOLFF NEO 400 Mode D'emploi Original

3.0 Maintenance
Additional weight (D)
►Only the original weight may be used. Never use
other weights or add additional weights as these
can cause the machine to become overloaded!
►WOLFF recommends that no more than
2 additional weights are used.
►Only WOLFF weights may be used.
Position the additional weight (2) at an angle and
snap in place
3.1 Mounting segments (C)
► Information on quick exchange of grinding
segments
- The grinding segments are inserted into
the groove and wedged outward by hammering
slightly (soft-head hammer).
- When grinding, the centrifugal force presses the
grinding segments to the outside.
- To replace worn segments, strike them to the
inside with a gentle hammer blow.
When centered, they can be removed easily.
3.2 Recommended segments (H)
► Depending on the substrate, different quantities
of diamond segments may be used. 4-9 segments
should be used as standard. Always ensure that
segments are distributed evenly over the disc
so as to prevent imbalance.
ES
► -segment: For preparing screed
For grinding and removing sintered layers of
screed and for removing thin paint layers on
soft mineral substrates.
Diamond segment ES, grit 20
Diamond segment ES, grit 40
Diamond segment ES, grit 60
PCD
► -segment
For aggressive removal of PU coatings,
putty mass and tile adhesives
(for thick adhesive layers).
Bodenschleifmaschine NEO 400, #76970
08/2015
#48028
BT
► -segment: For preparing concrete substrates
For grinding concrete, coatings and highgrade
compounds and for removing thin paint layers
on hard substrates.
Diamond segment BT, grit 20 #48038
Diamond segment BT, grit 40 #48041
Diamond segment BT, grit 60 #56303
PCD
►
For removing thin epoxy resin layers, paint,
synthetic resin, PU and dispersion adhesive.
Well suited for removing fleece backing and tex
tile double backing. (On hard sub-surfaces only.)
3.3 Set level regulator / body carriage (E)
► The machine must be positioned horizontally
when sanding/milling segments are attached.
For this purpose, the body carriage (8) may be
re-adjusted via the elongated holes of the level
regulator (7).
If the sanding segments have been used up, then
the machine may also be re-adjusted via the level
regulator (7) and positioned horizontally again.
The position may be checked using the provid
spirit level.

3.4 Dust extraction

► Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal can
be harmful to one's health. Touching or inhaling
the dusts can cause allergic reactions and/or lead
to respiratory infections of the user or bystanders.
Certain dusts are considered carcinogenic,
#56306
especially in conjunction with additives. Material
#56308
containing asbestos may only be handled by
#56309
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work area.
– The use of a P2 filter class respirator is
recommended.
-splinter segment #48036
20