Front Face; Protective Edges And Handles - Acoustics SB18 Manuel D'utilisation

SB18 8 8 8 SB1
SB1 SB1
COMPACT HIGH POWER SUBWOOFER COMPACT HIGH POWER SUBWOOFER COMPACT HIGH POWER SUBWOOFER COMPACT HIGH POWER SUBWOOFER
USER MANUAL USER MANUAL
USER MANUAL USER MANUAL
VERSION 1.2
8.3.2

Front face

Replacement kit and tools
KR SB18GR, electric screwdriver with torque selector (N.m or in.lb
Front face removal procedure
1. Put the enclosure front face towards user and logo down.
2. Undo the top and bottom Torx
bit). Note: It is not necessary to undo the center screw.
3. Remove the front face by pulling its right edge out and then extracting its left
studs from the enclosure.
Front face mounting procedure
1. Insert the studs of the front face into the left edge of the enclosure and push the right edge in place.
2. Drive two 35 mm round head Torx
in.lb ).
f
8.3.3

Protective edges and handles

Replacement kit and tools
KR SB18PRO, electric screwdriver with torque selector (N.m or in.lb
Protective edge removal procedure (x4)
®
1. Undo the five Torx screws on the protective edge (T30 bit).
2. Remove the protective edge from the enclosure.
Protective edge mounting procedure (x4)
1. Position the protective edge on the enclosure, feet pointing towards the bottom.
2. Drive two 35 mm flat head Torx
in.lb ). Note: The ends are located on the top and bottom faces of the enclosure.
f
3. Drive three 35 mm round head Torx
3 N.m/27 in.lb ).
f
Handle removal procedure (x2)
1. Undo the four hex screws and flat washers on the handle (5 mm hex bit).
2. Remove the handle from the enclosure.
Handle mounting procedure (x2)
1. Position the handle on the enclosure.
Add a flat washer to each of four 55 mm hex screws and drive them into the handle (thread-locker,
2.
5 mm hex bit, 3 N.m/27 in.lb
8.3.4 Pole mount socket
Replacement kit and tools
KR MCEMB3, electric screwdriver with torque selector (N.m or in.lb
Pole mount socket removal procedure
®
1. Undo the four Torx screws from the pole mount socket (T30 bit).
2. Remove the pole mount socket and the joint from the enclosure.
Pole mount socket mounting procedure
1. Position a joint around the pole mount socket location on the enclosure.
2. Position a pole mount socket on the enclosure and drive four 35 mm flat head Torx
bit, 5 N.m/45 in.lb ).
f
SB18_UM_ML_1-2
®
screws on the front right protective edge (T30
Figure 14: Right protective edge
®
screws into the right protective edge (thread-locker, T30 bit, 3 N.m/27
®
screws to the ends of the protective element (thread-locker, T30 bit, 3 N.m/27
®
screws to the side of the protective element (thread-locker, T30 bit,
).
f
w w w . l - a c o u s t i c s . c o m
®
), T30 Torx bit, KR LOCKBLUE.
f
®
), T30 Torx bit, 5 mm hex bit, KR LOCKBLUE.
f
®
), T30 Torx bit, KR LOCKBLUE.
f
®
screws (thread-locker, T30
Top screw
Center screw
Bottom screw
20 en 20 20 20