Connecting The Sb18 To The La4 Or La8 - Acoustics SB18 Manuel D'utilisation

VERTICAL
7.2.2

Connecting the SB18 to the LA4 or LA8

Each of the SB18 enclosures is connected to an LA4 or LA8 output channel ranging from channel 1 through 4. On the
LA8 only, additional cabinets can be grouped in pairs in parallel with the first ones. Therefore a single LA4 amplified
controller can drive up to four SB18 enclosures (Figure 7 and Figure 8), and a single LA8 amplified controller can drive
up to eight SB18 enclosures (Figure 9).
Note: The system resources are optimized for a multiple of four SB18 enclosures.
Figure 7: Four SB18 connected to an LA4 (stereo configuration)
IN A
Figure 8: Four SB18 connected to an LA4 (mono configuration)
SB18_UM_ML_1-2
BLOCK
HORIZONTAL
Figure 6: SB18 basic arrays in STANDARD mode
OUT 3 (IN B)
IN A
IN B
OUT 4 (IN B)
OUT 4 (IN A)
OUT 3 (IN A)
OUT 2 (IN A)
OUT 1 (IN A)
w w w . l - a c o u s t i c s . c o m
ON-END
OUT 1 (IN A)
OUT 2 (IN A)
Note: All output channels have been
routed to IN A by using the INPUT
MATRIX function on LA NETWORK
MANAGER Software (refer to the LA
NETWORK MANAGER
manual [3.4]).
Alternative solution: Plug an XLR
cable from LINK A to IN B on the
rear panel of the LA4 (refer to the
LA4 User manual [3.4]).
EN
User
13 en 13 13 13