Denon Professional DN-500BD MKII Guide D'utilisation page 27

•
Setting
Interface: Select how DN-500BD MKII will access the internet: Ethernet (the LAN port
o
must be connected to your Ethernet connection) or Wireless (DN-500BD MKII will
connect to your wireless router). When you change this setting, you will be asked if you
want to continue, which terminates your current connection. When you select Wireless,
you must also select how you want to connect to the network: Scan (display available
networks), Manual (enter the network service set identifier [SSID] manually), or Auto
(use Wi-Fi Protected Setup [WPS]).
If you select Auto, select how you will connect to the network: PBC (press the
WPS/Reset button on your router within 120 seconds of selecting Next) or PIN (enter
the PIN shown on the screen into the software control panel for your wireless router or
access point).
o Information: This option opens a window that shows the following information about
your internet connection: Interface, Address Type, IP Address, Subnet Mask, Default
Gateway, DNS1, and DNS2. (If DHCP is set to Off, you can enter this information
manually with the remote control. See below.) Press Return to return to the previous
menu.
o Connection Test: Select this option to check DN-500BD MKII's connection to the
internet.
o DHCP: When set to On, DN-500BD MKII will obtain IP address information via Dynamic
Host Configuration Protocol (DHCP). When set to Off, you must enter the IP address,
Subnet Mask, Default Gateway, DNS1, and DNS2 manually:
 Use the left/right cursor buttons () to move between the squares.
 Use the number buttons (0–9) to select numbers for each square.
 Press the down cursor button () to delete a number.
 Press OK to confirm the entire address.
 Press Return to cancel and return to the previous menu.
o Wireless Setting: Select how you want to connect to the wireless network: Scan
(display available networks), Manual (enter the network service set identifier [SSID]
manually), or Auto (connect automatically to an available network). The Interface setting
(see above) must be set to Wireless.
If you select Auto, select how you will connect to the network: PBC (press the
WPS/Reset button on your router within 120 seconds of selecting Next) or PIN (enter the
PIN shown on the screen into the software control panel for your wireless router or
access point).
o Proxy Setting: When set to Disable, DN-500BD MKII will not use a proxy server. When
set to Enable, DN-500BD MKII will use a proxy server with the information in the Proxy
Host and Proxy Port windows.
 Proxy Host: Use the cursor buttons () to move between the buttons in the
window. Press OK to press that button. Press Return to return to the previous menu.
 Proxy Port: Use the number buttons (0–9) to select numbers for each square. Press
Return to return to the previous menu.
27