Philips HP4674 Mode D'emploi page 7

- Do not insert metal objects into the air inlet grille to avoid electric
shock.
Warning
- Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
- Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
caution
- For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
- The attachments become hot during use. Prevent contact with the
skin.
- Never block the air inlet grille.
- If the appliance overheats, it switches off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch
the appliance back on, check the grilles to make sure they are not
blocked by fluff, hair, etc.
- Always unplug the appliance after use.
- Wait until the appliance has cooled down before you store it.
- Always switch off the appliance before you put it down, even if it is
only for a moment.
- Do not wind the mains cord round the appliance.
- Do not use the appliance on artificial hair.
EnglisH
7