Table des Matières
Publicité
English
Preliminary procedures
Check that the coffee bean receptacle (2) is correctly positioned on the
coffee grinder-distributor, lift the lid (1) and fill with coffee beans. Check
that the gate (3) is completely open and push towards the inside.
Switching on
"Before switching on the machine, ensure that the mains
!
switch is on".
Turn switch (11) to position "1" to switch on the machine and check that
the indicator light "ON" (10) is lit.
This machine has an automatic switch-off device that is activated each
time the coffee distributor (6) is sufficiently full of ground coffee. By leaving
the on-off switch (11) on position "1", the coffee grinder-distributor will
automatically start working again when the level of ground coffee needs
to be topped up again.
At the end of the working day, switch off the machine by turning the on-
off switch (11) to position "0". The indicator light (10) is switched off.
Regulating the grind
The machine may be adjusted for different grindings (from fine to course)
via a screw (4) as shown on the graded indicator (15).
If the flow of the coffee from the machine is very slow, this indicates that
the coffee is too finely ground. It will therefore be necessary to turn the
screw (4) anti-clockwise to obtain a coarser grind.
If the flow of the coffee from the machine is very fast, this indicates that
the coffee is too coarsely ground. It will therefore be necessary to turn
the screw (4) clockwise to obtain a finer ground.
Removing the ground coffee
Position the coffee machine filter basket on the bracket (12) and push it
until it comes into contact with the stock (19).
Pull the ground coffee distribution lever (9) towards yourself to obtain a
dose of coffee (one dose corresponds to a cup of coffee) and allow the
lever to return to its initial position automatically.
Turn the filter basket towards the coffee tamper (7) and press the coffee
by pushing the coffee tamper down (7).
Setting at work
1
2
3
OPEN
Switching on
"Before switching on the machine, ensure that the mains
!
switch is on".
Turn switch (11) to position "1" to switch on the machine and check that
the indicator light "ON" (10) is lit.
When there is enough ground coffee in the doser (6), switch off the
machine turning the main switch (11) to the "0" position.
N.B. Do not overfill the ground coffee doser.
At the end of the working day, switch off the machine by turning the on-
off switch (11) to position "0". The indicator light (10) is switched off.
Use
7
19
12
CLOSE
COARSE
FINELY
+
-
4
English
9
Publicité
Table des Matières
