Kickback - Remington BRANCH WIZARD Manuel Du Propriétaire

IMPORTANT SAFETY INFORMATION
12. Do not force Pole Saw while cutting. Apply light
13. When cutting a limb that is under tension, use
14. Carry Pole Saw from one place to another
15. Do not cut small brush and saplings with the Pole
For parts contact: www.PartsFor.com
pressure. It will do the job better and safer at the
rate for which it was intended.
extreme caution. Be alert for wood springing
back. When wood tension is released, limb could
spring back and strike operator causing severe
injury or death.
• with unit unplugged
• by holding pole at balance point (close to saw
end)
• with guide bar and chain to rear
Saw. Slender matter may catch in the chain and
be whipped toward you. This could also pull you
o balance.
WARNING: This product contains
chemicals known to the State of Cali-
fornia to cause cancer or birth defects,
or other reproductive harm.
WARNING: Some dust created by
power sanding, sawing, grinding, drill-
ing, and other construction activities
contains chemicals known (to the state
of California) to cause cancer, birth de-
fects, or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints
• crystalline silica from bricks and ce-
ment and other masonry products
• arsenic and chromium from chemi-
cally-treated lumber
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well venti-
lated area, and work with approved safety
equipment, such as those dust masks
that are specially designed to
microscopic particles.

KICKBACK

WARNING: Kickback may occur when
the nose or tip of the guide bar touches
an object, or when the wood closes in
and pinches the saw chain in the cut.
Tip contact in some cases may cause a
lightning fast reverse reaction, kicking the
guide bar up and back towards the opera-
tor. Pinching the saw chain along the top
of the guide bar may push the guide bar
rapidly back towards the operator. Either
of these reactions may cause you to lose
control of the Pole Saw which could result
in serious injury to user.
Kickback Safety Devices On This Pole
Saw
This Pole Saw has a low-kickback chain and re-
duced kickback guide bar. Both items reduce the
chance of kickback. Kickback can still occur with
this Pole Saw.
The following steps will reduce the risk of kick-
back.
• Use both hands - one gripping the handle and the
other gripping the pole. Use firm grip. Thumbs and
fingers must wrap around pole and handle.
• Keep all safety items in place on Pole Saw. Make
sure they work properly.
• Do not overreach or extend arms above shoulder
height.
• Keep solid footing and balance at all times.
• Never try cutting through two branches at the same
time. Only cut one at a time.
• Do not bury guide bar nose or try plunge cut (boring
into wood using guide bar nose).
• Watch for shifting of wood or other forces that may
pinch chain.
• Use extreme caution when reentering a previous
cut.
• Use low-kickback chain and guide bar supplied
with the Pole Saw. Only use replacement parts
listed for the Pole Saw.
• Never use dull or loose chain. Keep chain sharp
with proper tension.
lter out
MAINTENANCE AND STORAGE OF
POLE SAW
Unplug Pole Saw from power source and follow
maintenance and storage procedures outlined in
Cleaning and Maintenance and Storage.
5