Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Service
orized per so n nel may result in misplacing
of internal wires and components which
could
cause
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho -
rized Bosch Service Station.
SERVICE REMINDER LIGHT
When the service reminder light lights up or
blinks, this will indicate that the cut-out
carbon brushes will switch off the tool in
approximately 8 hours. After that period, the
light will go off and the tool will stop running.
The tool must then be sent to a service
center for service.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Bosch replace ment brushes
specially designed for your tool should be
used.
BEARINGS
After about 300-400 hours of operation, or at
every second brush change, the bearings
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
Auxiliary Handle*
Carrying case*
Preventive maintenance
performed by unauth-
serious
hazard.
Extension Cords
If an extension cord is
necessary, a cord with
Maintenance
should be replaced at Bosch Factory Service
Center or Au thorized Bosch Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
We
REPLACEMENT OF CORD AND
Your tool is designed to provide a qualified
service technician optimal access to replace
the carbon brushes and the cord. This
provides the service technician the ability to
replace these components without the need
of disassembling the entire tool housing.
tool from the power supply before
cleaning or performing any main tenance.
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety gog gles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents,
detergents that contain ammonia.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Tool's
Ampere
Rating
3-6
6-8
8-10
10-12
12-16
Accessories
(*= standard equipment)
(**= optional accessories)
-11-
CARBON BRUSHES
Cleaning
To
avoid
always dis connect the
Certain cleaning agents
and sol vents damage
ammonia
and
Cord Size in A.W.G.
Cord Length in Feet
25
50
100
150
18
16
16
14
0.75
18
16
14
12
0.75
18
16
14
12
0.75
16
16
14
12
1.0
14
12
–
–
accidents
house hold
2
Wire Sizes in mm
Cord Length in Meters
15
30
60
120
0.75
1.5
2.5
1.0
2.5
4.0
1.0
2.5
4.0
2.5
4.0
–
–
–
–
–
Publicité
Table des Matières
