Special Safety Instructions; Noise And Vibration - Flex MXE 18.0-EC Notice D'instruction D'origine

Special safety instructions

 Use only original batteries with the
voltage indicated on the type plate of
your power tool. The use of other
batteries, e.g. imitations, reconditioned
batteries or other makes, increases the risk
of injury and damage to property by
exploding batteries.
 Recharge batteries only with chargers
recommended by the manufacturer.
A charger that is suitable for one type of
battery may create a fire hazard when used
with another battery.
 Pointed objects, such as nails or
screwdrivers, or external forces may
damage the battery. This may cause an
internal short-circuit and the battery to
burn, smoke, explode or overheat.
 Protect the battery against heat,
including prolonged sunshine, fire, water
and moisture. Explosion hazard!
 If the battery is damaged or used
improperly, fumes may be emitted. Ensure
a supply of fresh air and consult a doctor if
you feel unwell. The fumes may irritate the
respiratory tracts.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A-weighted noise level of the power tool
is typically:
– Sound pressure L
– Sound power L
– Uncertainty K:
Vibration total value (when mixing mineral
materials of medium viscosity):
– Emission value a
– Uncertainty K:
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
14
: 73 dB(A);
pA
: 84 dB(A);
WA
: <2.5 m/s
h
1.5 m/s
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use. This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
3 dB.
2
2
MXE 18.0-EC