Battery/Battery Charger Safety Warnings - EGO CHT2000E Manuel De L'opérateur

ADDITIONAL GENERAL POWER TOOL SAFETY
WARNINGS
Only remove trimmings when the product is switched
off and remove the battery pack.
Use only with the battery packs and chargers listed
below:
BATTERY PACK
CBA0240
Do not try to grasp or remove trimmings when the
product is running.
Only remove trimmings when the product is switched
off and remove the battery pack.
Always be sure of a safe and secure operating position,
whilst using the product. Always be sure of your footing
when using steps and when using your product.
Do not overload the product.
Check immediately if the product starts to vibrate
abnormally. Excessive vibration can cause injury.
Follow the maintenance and repair instructions for
this product. Never carry out any modifications of the
product. Information about maintenance and repair is
provided in this user manual.
Use the product only in daylight or good artificial light.
Switch on the motor only when the hands and feet are
away from the cutting device.
Always remove the battery pack.
- whenever leaving the product unattended
- before clearing a blockage
- before checking, cleaning or working on the product
- after striking a foreign object
- whenever the product starts vibrating abnormally
Take care against injury to feet and hands from the
cutting device.
Always ensure that the air vents are kept clear of debris.
Never allow people unfamiliar with these instructions
or children to use the product. Local regulations can
restrict the age of the operator.
Never operate the product while people, especially
children, or pets are nearby.
Wear eye protection and stout shoes at all times while
operating the product.
Inspect and maintain the product regularly. Have the
product repaired only by an authorized person.
When not in use, store the product out of the reach of
children.
CHARGER
CCH0450E
electromagnetic field during operation. This field
may under some circumstances interfere with active
or passive medical implants. To reduce the risk of
serious or fatal injury, we recommend persons with
medical implants to consult their physician and the
medical implant manufacturer before operating this
machine.

BATTERY/BATTERY CHARGER SAFETY WARNINGS

12-VOLT LITHIUM-ION GRASS/SHRUB SHEAR — CHT2000E
Only use the battery pack provided with the appliance.
Keep supply and extension cords away from cutting
means.
Never operate the machine with damaged guards or
shields or without guards or shields in place.
Use only the manufacturer's recommended
replacement parts and accessories
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
WARNING:
This machine produces an
Protect the battery charger from rain and moisture. The
penetration of water in a battery charger increases the
risk of electric shock.
Pecharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
Do not charge other batteries. The battery charger is
sutitable only for charging lithiumion bateries within
the listed boltage range. Therwise there is danger, fire
and explosion.
Keep the battery clean. Contanmination may cause the
danger of electric shock.
Check the battery charger, cable and plug each
time before using. Do not use the battery charger
when defects are detected. Do not open the battery
charger yourself and have it repaired only by qualified
personnel using original spare parts. Damaged battery
chargers, cables and plugs increase the risk of electric
shock.
Do not operate the battery charger on easily
inflammable surfaces(e.g. paper,textiles,etc.)or in
combusible environments. There is danger of fire due
to the heating of the battery charger during charging.
EN
7