Publicité
User Manual
Introduction
Thank you for purchasing the USB 3.1 Docking & Clone Station. This product has been designed to provide
trouble free, reliable operation. It benefits from both a LINDY 2 year warranty and free lifetime technical
support. To ensure correct use, please read this manual carefully and retain it for future reference.
Package Contents
• USB 3.1 Gen 2 Docking & Clone Station
• USB 3.1 Gen 2 Type C to A connection cable ~90cm
• USB 3.1 Gen 2 Type C to C connection cable ~90cm
• External Level VI power supply 12V 4A with ~1m DC cable with 5.5/2.5mm round connector
• 4 power cables (Euro/UK/US/AUS)
• Foam pad (50x50x6mm) for 7mm HDDs
• LINDY manual
Features
•
Connects two SATA HDD/SSDs to a computer using a single connector
•
Accepts 1.8/2.5/3.5" HDD/SSDs with 22 pin SATA combo interface. For Micro SATA please use LINDY
adapter No. 33502.
•
Offline clone function (OS independent) with button for cloning from slot A (source) to slot B (target)
•
USB 3.1 Gen 2 SuperSpeed+ Interface up to 10Gbps
•
SATA 6.0Gbps standard
•
Interfaces: USB Type C socket, DC 12V power socket
•
On/Off power switch
•
LEDs for power, slot A, slot B, clone process
•
Compatible with USB equipped computers
Installation & Use
•
Connect the power supply
•
If you want to clone HDDs, do not connect the Docking Station to your computer
•
For normal docking station operation connect the Docking Station to your computer via USB cable
•
Insert the HDDs in to the docking station and press the power switch to turn on
•
Wait until the drivers are loaded by the operating system – you should then see the drives in the file
manager program
•
HDDs may need to be partitioned / formatted using your operating system disk management utility
before you can access them.
•
Before unplugging HDDs make sure data transfer processes are completed
Using the Clone Function
•
Install the source and target HDDs into the appropriately labelled slot A (source) and B (target)
•
The target HDD must be of equal or larger capacity than the source HDD
•
Make sure that the target HDD is empty and not partitioned
•
When both drives are connected, press and hold the clone button for 3 seconds until the LED for
100% cloning is lit up. Then the button must be pressed again to start the clone process. All 4 LEDs
(3) light up once the clone process has ended (percent status changes as clone progresses).
Do not switch off or unplug the HDDs during the cloning process!
English
Publicité
