Installation Instructions; Before Using Your Wine Chiller; Installation Of Your Wine Chiller; Built-In Cabinet Instructions - Avanti WCR5449SS Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 BEFORE USING YOUR WINE CHILLER
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
5 Roll-out Shelves
1 Small Bottom Shelf
1 Instruction Manual
Before connecting the Wine Chiller to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
 INSTALLATION OF YOUR WINE CHILLER
This appliance is designed to be for free standing, recessed, or built-in installation.
Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To
level your Wine Chiller, adjust the front leveling legs at the bottom of the Wine Chiller.
Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the protective coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
Do not let anything cover or obstruct the ventilation grilles.
Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a
built-in application please follow the requirements shown to the right.
Unit Dimensions
Width
Depth
(with handle)
Depth
(without handle)
Height

INSTALLATION INSTRUCTIONS

IN (min)
MM (min)
1
"
597 mm
23
/
2
1
25
/
"
641 mm
4
23 ¾"
603 mm
3
33
/
"
857 mm
4
Figure shown
Cabinet Opening Dimensions
IN (min)
Width
24"
Depth
26"
Height
35"
7
MM (min)
610 mm
661 mm
889 mm

Publicité

Table des Matières
loading

Table des Matières