Storage; Interior Light; Shelves - Avanti WCR5449SS Manuel D'instructions

NOTE:
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Chiller will not start.
•
When you use the wine chiller for the first time or restart the wine chiller after having been shut
off for a long time, there could be a few degrees variance between the temperature you select
and the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the wine chiller is running for a few hours everything will be back to
normal.
 STORAGE
Many bottles may differ in size and dimensions. As such the actual number of bottles you may be
able to store may vary.
NOTE: You can place approximately 49 standard bottles (750ml capacity) in your unit.
 INTERIOR LIGHT
If you would like the light ON press the
light will automatically turn OFF after 10 minutes.
 SHELVES
This appliance is equipped with a pull-out roller assembly (except for the bottom shelf) and you can
move the wooden shelves out and in smoothly.
Pull-out Roller Shelves (Total 5)
•
To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
•
For easy access to the bottles, you must pull the shelves approximately 60% out of the rail
compartment.
•
To remove the shelves out of the rail pull each shelf approximately 60% out. Use a long flat
screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift
the left plastic notch as shown in Figure B. Then proceed to pull out the shelf slowly. Contact
our service department if assistance is needed.
Figure A
button and the interior light will be turned ON. The
Figure B
11