HunterDouglas EM304 Instructions D'utilisation

HunterDouglas®
Electrical controller
Instruction for use Instruction for use
The HunterDouglas® electrical controller EM304 for sliding shutters enables the user to move the The HunterDouglas® electrical controller
connected motorized sliding shutter in left or right direction by means of sliding shutter in left or right direction by means of an external open/close switch, a
remote control or a central building control unit. remote control or a central building control unit
For further information regarding the installation and connection of the shutter and the controller please For further information regarding the instal
refer to the corresponding manuals. This user instruction will explain the functionality of the shutter once it refer to the corresponding manuals. This user instruction will explain the functionality of the shutter once it refer to the corresponding manuals. This user instruction will explain the functionality of the shutter once it
has been correctly installed.
Normal functionality
A short push on a button will make the shutter move in the corresponding direction. The shutter will slow
down and stop a short distance before and stop a short distance before the end stop.
If any button is pushed while the shutter is moving the shutter will stop. button is pushed while the shutter is moving the shutter will stop.
If during travel the shutter is blocked by an o If during travel the shutter is blocked by an obstacle the controller will notice this and stop the motor
immediately. The shutter will reverse for 10 cm to allow the obstacle to be removed. Any next command The shutter will reverse for 10 cm to allow the obstacle to be removed. Any next command The shutter will reverse for 10 cm to allow the obstacle to be removed. Any next command
will send the shutter back to reset its starting point. After this the shutter functions normal
Warning: it is not advised to move the shutters manually. If necessary the shutters should only be pushed it is not advised to move the shutters manually. If necessary the shutters should only be pushed it is not advised to move the shutters manually. If necessary the shutters should only be pushed
carefully at low speed. Pushing the shutter faster than normal running speed may carefully at low speed. Pushing the shutter faster than normal running speed
the controller.
Reset procedure
If for any reason the end position settings are no longer correct, a reset can be made for any reason the end position settings are no longer correct, a reset can be made for any reason the end position settings are no longer correct, a reset can be made by pushing once the
reset button on the controller (see illustration below)
learn its travel distance to the other endpoint learn its travel distance to the other endpoint. When this is finished the shutter is ready for use again.
ler EM304 for sliding shutter
lation and connection of the shutter and the controller please
l make the shutter move in the corresponding direction. The shutter will slow l make the shutter move in the corresponding direction. The shutter will slow
bstacle the controller will notice this and stop the motor
to reset its starting point. After this the shutter functions normally again. to reset its starting point. After this the shutter functions normal
(see illustration below). The shutter will move to one end point and then
. When this is finished the shutter is ready for use again.
for sliding shutters enables the user to move the
. The shutter will move to one end point and then
Instruction for use HunterDouglas® electrical sliding shutter controller
an external open/close switch, a
damage the motor or
electrical sliding shutter controller EM304