Télécharger Imprimer la page

HunterDouglas Platinum Guide De Démarrage Rapide

Publicité

Liens rapides

Platinum
App Bridge Kit
Trousse de pont pour
App Platinum
MC
Quick Start Guide
Guide de
démarrage rapide

Publicité

loading

Sommaire des Matières pour HunterDouglas Platinum

  • Page 1 Platinum App Bridge Kit ™ Trousse de pont pour App Platinum Quick Start Guide Guide de démarrage rapide...
  • Page 2 Check kit contents. Vérifier le contenu de la trousse. A. Platinum App Bridge A. Pont pour App Platinum ™ B. DC Power Supply B. Bloc d’alimentation c.c. C. USB Power Supply Cable C. Câble d’alimentation USB D. Ethernet Cable D. Câble Ethernet E.
  • Page 3 Connect power to bridge. Connecter le pont à l’alimentation électrique. Connect the USB power supply cable to the power supply and bridge. Plug the power supply into an AC outlet or power strip. Connectez le câble d’alimentation USB au bloc d’alimentation et au pont. Branchez le bloc d’alimentation sur une prise c.a.
  • Page 4 Connecter le pont au routeur sans fil. Connect the Ethernet cable to the bridge and an open LAN port on your router. The light on the front of the Platinum App Bridge will flash while it boots up and then change to a solid GREEN Connectez le câble Ethernet au pont et à...
  • Page 5 See the instructions that came with the Platinum Repeater Kit. On recommande d’installer un répéteur par pièce ayant des couvre-fenêtres avec PowerRise 2.1 et/ou PowerGlide 2.1. Consultez les instructions qui accompagnent la trousse de répéteur Platinum.
  • Page 6 Test signal to repeater(s). Vérifier l’émission d’un signal vers les répéteurs. Press the button on the back of the Platinum App Bridge. The light on ™ each Platinum Repeater should turn GREEN Other controls on the back of the bridge include the...
  • Page 7 You’re ready to use the Platinum App. Vous êtes prêt à utiliser l’App Platinum. A. Platinum App Bridge A. Pont pour App Platinum B. Platinum Repeater B. Répéteur Platinum...
  • Page 8 U.S. Radio Frequency FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.