Klarstein 10032301 Manuel D'utilisation page 21

4 Attach the M10 * 30 screw cylinder to the suspension plate and secure it with
two M10 nuts. Make sure that the upper part of the screw cylinder is not higher
than the upper part of the suspension plate (see figure 2).
5 Mount the four adjustable M5 * 28 screws and guide the wire ropes over the
adjustable screws to set them to the correct length. Use the wire rope locking
screw M4 * 10 to tighten the adjustable screws. Make sure that all 4 wires
have the same length (see figure 3).
6 If the ceiling is made of wood, mark the holes using the suspension plate and
drill 8 holes in the ceiling. Then attach the suspension plate to the wooden
ceiling with eight ST6 * 40mm sinker screws. If the ceiling is concrete, drill only
4 holes and fix the suspension plate to the concrete ceiling with four Ø6 * 60
anchor bolts (see figure 4).
7 Attach the decorative plate to the suspension plate (see figure 5).
8 Attach the hood to the wire rope and use the ST4 * 8mm countersunk screws to
secure the wire rope and prevent it from slipping out (see figure 6).
EN
21