Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anti - tip Bracket considerations
Before placing the cabinet in opening, the depth of the
cut-out opening should be at least 24" (61cm). If the cut-out
opening depth is more than 24" (61cm), then a piece of
wood must be secured crosswise on the wall into the studs
at the height of the anti-tip brackets. (See Figure 8). Slide
the cabinet into position and level the cabinet with adjust-
able rear roller and front leveling legs. (See Leveling the
unit on page 12).
The anti tip bracket is fastened to the cabinet and runs the
full width of the cabinet. Locate a wall stud behind the cabi-
net and secure the anti-tip bracket with at least (2) #8 x 1
screws provided. See Figure 7.
Figure 7
INSTALLING THE CABINET
⁄
"
1
2
-Wall stud
-Anti-tip
bracket
on top of
cabinet
-At least 2
screws into
wall stud.
11
-Crosswise
lumber
Figure 8
Publicité
Chapitres
Table des Matières
