Selecting A Location; Visual Check - Bond BH5001-1 Guide D'utilisation

WARNING
** DO NOT COVER THE IGNITION SCREEN when placing the
lava rocks into the fire bowl. Always keep Ignition Screen visible.
This screen must be clear and free of obstructions at all times to
insure proper operation.
The burner of the fireplace must be covered by
lava rocks
Otherwise the flame may
occasionally. See the Figure CORRECT and
INCORRECT for reference.
LP (Liquid Propane) gas supply connection
• Always confirm that the burner control knob is in the OFF position before connecting the gas suppl
• Do not obstruct the flow of combustion air and ventilation air to the appliance.
To Connect:
1 Ensure that there is no debris caught in the head of gas cylinder, head of the regulator valve.
2 Insert the nipple of the valve coupling into the cylinder valve and tighten the black coupling nut
by turning it clockwise with one hand while holding the regulator with the other hand. (See
diagram.) Hand tighten only.
To Disconnect:
1 Always confirm that the cylinder valve is in the OFF position
before disconnecting the gas supply.
2 Hold the regulator with the one hand and loosen the black
coupling nut by turning it counter-clockwise with the other
hand. (See diagram.)
IMPORTANT
Disconnect the propane cylinder from the regulator valve when the appliance is not in use.

SELECTING A LOCATION

Always place this outdoor appliance on a hard, level non-combustible
surface such a concrete, rock or stone.
Minimum Clearance from Unit to Combustible Materials
72"(182.9cm) from the top; 48" (121.9 cm) from all sides and back.
Do not locate this appliance under any overhead enclosure.
Position the appliance so that you have easy access to the control
knob.

VISUAL CHECK

Prior to each use, check the hose and valve for excessive wear or abrasions.
completely.
be extinguished
Correct
8
Incorret
y.