Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
a) Inspect the hose before each use of the appliance. If the hose shows signs of cracks, abrasions, cuts or damage of any kind, do not
operate the appliance. Fix or replace the hose as required before using the appliance. For assistance with repair or
replacement of the hose, call Bond Manufacturing at 1-866-771-2663. Use only replacement parts from the manufacturer.
b) Inspect the seal inside the CGA No 791 service valve on the LP gas cylinder when replacing the cylinder or at least once per year.
If there is any indication of damage, have the seal replaced by a certified gas dealer before operating the appliance.
4
Do not use tools to tighten the CGA No 791 connection nut onto the LP gas cylinder service valve.
Hand tighten only.
5
Be careful to not cross the threads on the connection when tightening the CGA No 791 connection on to the LP gas cylinder
service valve.
6
"Leak Test" should always be performed after attaching the connection to the LP gas cylinder service valve.
(See "Leak Test" section of this manual)
7
For the connection of the hose and regulator to the LP tank, refer to the "Connection" section of the LP gas cylinder
section above.
WARNING
LAVA ROCK USE
1. Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before lighting as intense heat could
cause the lava rocks to crack.
2. Lava rocks could hit somebody' face or eyes during the initial start of this unit, so please keep away from the appliance for the
first 20 minutes.
5
Publicité
Table des Matières
