golmar Nexa Modular GB2 Guide Rapide page 3

GB2 AUDIO AND VIDEO DOOR ENTRY SYSTEM - PROXIMITY READER MODULE
( ) PROGRAMMING THE DOOR PANEL
*
Managing proximity keys:
For resident proximity key access and management, the system must have an N3401/GB2 proximity
access control module. TK3401/GB2 key kit not included
IMPORTANT: It is necessary to initially activate the MASTER CARD ADD and MASTER CARD
DELETE keys on the door panel to be managed
Adding resident keys:
Hold the MASTER CARD ADD key near to the N3401/GB2 proximity reader,
(Step 1)
communication indicator will illuminate and the door panel will emit a long and then
short tone to indicate that it is in
One by one, hold all of the keys to be added to the door panel near to the N3401/GB2
(Step 2)
proximity reader. The door panel will emit a long tone each time it stores a proximity
key or two short tones if the key has already been stored. A maximum of 320 access
keys can be stored.
Once all resident proximity keys have been added, complete the process by holding
(Step 3)
the MASTER CARD ADD key near to the N3401/GB2 proximity reader.
Communication indicator will turn off and the door panel will emit a short and then
long tone to indicate that it has exited
Deleting resident keys:
Hold the MASTER CARD DELETE key near to the N3401/GB2 proximity reader,
(Step 1)
communication indicator will illuminate and the door panel will emit a long and then
short tone to indicate that it is in
One by one, hold all of the keys to be deleted from the door panel near to the
(Step 2)
N3401/GB2 proximity reader. The door panel will emit a long tone each time it deletes
a proximity key or two short tones if the key does not exist on the door panel.
Once all resident proximity keys have been deleted, complete the process by holding
(Step 3)
the MASTER CARD DELETE key near to the N3401/GB2 proximity reader. Door
open indicator will turn off and the door panel will emit a short and then long tone
to indicate that it has exited
'Delete resident keys'
Deleting all resident proximity keys:
Hold the MASTER CARD DELETE key near to the N3401/GB2 proximity reader,
(Step 1)
communication indicator will illuminate and the door panel will emit a long and then
short tone to indicate that it is in
Then hold the MASTER CARD ADD key near to the N3401/GB2 proximity reader,
(Step 2)
communication indicator will illuminate and the door panel will emit a long and then
short tone to indicate that it is in
Finally, hold the MASTER CARD ADD key again to the N3401/GB2 proximity reader to
(Step 3)
confirm deletion of all resident keys from the door panel. During the deletion process,
the communication and door open indicators will blink. When complete, they will turn
off.
( )
For more information, see the "TCODE/CA GB2 user manual (code
*
https://doc.golmar.es/search/manual/50122371
.
before resident keys can be added/deleted
'Add resident keys ' mode.
'Add resident keys' mode.
'Delete resident key s' mode.
mode.
'Delete resident key s' mode.
'Delete all proximity keys ' mode.
50122371)".
4
.
Proximity Reader Module
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
Code 50122371
Nexa Modular GB2
2-Wire
QUICK GUIDE
TN3401/GB2 EN
golmar@golmar.es www.golmar.es
Sistemas de comunicación S.A.
GR
REV.0 17 2