Hilti RC 4/36 Mode D'emploi Original page 11

Establishing a Bluetooth connection
Note
If you are prompted for a code, enter the code 0000.
Making an NFC connection
Setting the audio source
Note
Press the mode button to select the audio source: AM, FM, AUX or Bluetooth.
Searching for and saving stations
Note
Quickly turn the knob a short distance to start the automatic station search.
Positioning the antenna
Adjusting the volume
Equalizer settings
Note
This allows you to make adjustments to the bass and treble settings.
Audio playback from an external device via AUX
USB charging function
Note
The USB charging function is available only when the appliance is connected to an AC
supply or, if in battery mode, when it is switched on.
Note
The USB connector provides charging power only.
6 Troubleshooting
6.1 The appliance is connected to the AC supply
Malfunction
Border of the battery sym-
bol flashes, no segment of
the state of charge indicator
filled.
6.2 Appliance in battery-powered operation
Malfunction
The appliance does not start.
Printed: 26.07.2017 | Doc-Nr: PUB / 5296537 / 000 / 03
Possible cause
Battery too hot
Battery too cold
Battery defective
Possible cause
Battery discharged
Battery defective
Appliance defective
Action to be taken
▶ Wait until the battery cools
down.
▶ Wait until the battery warms up.
▶ Check the battery by pressing
the two buttons at the sides.
If the LEDs light up the Radio
Charger might be defective. If
the LEDs do not light up the
battery is defective.
▶ Contact Hilti Service.
Action to be taken
▶ Charge the battery, insert a
new battery, or connect the
appliance to the AC supply.
▶ Check the battery by pressing
the two buttons at the sides.
If the LEDs light up the Radio
Charger might be defective. If
the LEDs do not light up the
battery is defective.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
English
7
8
9
10
11
12
13
14
15
5