Indel B SAFE 10 BOX Mode D'emploi page 17

CHANGING CODES
CHANGING THE PERSONAL CODE
Enter the new Personal Code, from 4 to 6 digits, close the Safe door and push the LOCK key.
The display will read CLOSE, which will change to CLOSED and then the Personal Code will be
displayed as a reminder for the user.
CHANGING THE MASTER CODE
WARNING
We recommend changing the default Master Code as the same code is set forl the safes in the
factory.
Once you have changed the Master Code, make a note of the new Code and keep it in a safe
place.
With the Safe door open, key in the original Master Code (6 digit code: 848711) and press the RESET
key. The display will read NEW and you can then enter the new Master Code, also 6 digits long.
Once you have entered the new Master Code, press the LOCK key again. The display will read
AGAIN, so key in the new Master Code a second time and press LOCK again.
If the Master Code has been changed correctly, the display will read DONED.
USE OF AN EXTERNAL FEEDER
In case of battery exhaustion, while the Safe is closed, it is possible to open it using the External Feeder.
Insert the 4 AA batteries supplied with the package, respecting the polarities indicated on the
feeder compartment; connect the feeder plug to the socket of the Safe displayed in the figure.
At this point the Safe will go back to standard operating mode and you will be able to open it for
the replacement of the internal batteries.
SAFE 10 BOX
BATTERIES
EXTERNAL POWER
SUPPLY UNIT
SAFE 30 BOX
15
REMOVABLE
FRONT PANEL