Indel B SAFE 10 BOX Mode D'emploi page 16

SAFE 10/30 BOX
INSTRUCTIONS FOR USE
The Safe, after the installation, appears to the user with the door open and with the Double code system
already set by the Manufacturer.
Personal code (of 4 digits, for ordinary use) and Master code (of 6 digits, for emergency openings).
Adhere to the following instructions for Ordinary use.
SAFE CLOSURE
Enter a Personal code (from 4 to 6 digits) and press the LOCK key. The display will show the message "CLOSE".
When the door is closed, the display will show the message "CLOSED" and subsequently the Personal code
entered, as a memorandum to the user.
In the front panel of the Safe, a short illustrated sequence is reported describing the door opening and
closure procedures.
SAFE OPENING
In order to open the Safe, simply enter the Personal Code (from 4 to 6 digits).
If one or more wrong numbers are typed on the keyboard, it is possible to delete them by pressing the
RESET key.
WARNING
If a wrong Personal code (from 4 to 6 digits) is entered for three consecutive times, the Safe will be inactive
for 15 minutes, during this period, if any key is pressed, the display will show the message "HOLD+DIGIT"
After 15 minutes, the Safe can be re-used.
WARNING
In case of dead batteries (voltage lower than 5V) the message "LO-BAT" will appear on the display; in this
case replace the batteries, as indicated in the section "BATTERY INSERTION".
SAFE_10_30_BOX_IM_20190507
14