Inspection Before Use; Précautions - BWT Comfort BPNR05 Manuel D'utilisation

VII. Testing

1. Inspection before use

A. Check installation of the whole machine and the pipe connections
according to the pipe connecting drawing;
B. Check the electric wiring according to the electric wiring diagram
and earthing connection;
C. Make sure that the main machine power switch is off;
D. Check the temperature setting;
E. Check the air inlet and outlet.
2. Trial
A. The user must "Start the Pump before the Machine, and Turn off the
Machine before the Pump", or the machine will be damaged;
B. The user should start the pump, check for any leakage of water; and
then set suitable temperature in the thermostat, and then switch on
power supply;
C. In order to protect the swimming pool heater, the machine is
equipped with a time lag starting function, when starting the
machine, the blower will run 1 minutes earlier than the compressor;
D. After the swimming pool heater starts up, check for any abnormal
noise from the machine.
VIII. Precautions
1. Attention
A. Set proper temperature in order to get comfortable water
temperature to avoid overheating or overcooling;
B. Please don't stack substances that can block air flow near inlet or
outlet area, or the efficiency of the heater will be reduced or even
13