Pc Mode; Operation With Additional Devices; Special Functions - Medion Pure Retro Mode D'emploi

Then the television channel last selected (programme number) appears on screen.
If the menu option <SETTING ' INFO SIGNAL SOURCE> is "On", the following info window for signal source is displayed
for approx. 5 seconds:
TV - - 2 - - ZDF
STEREO
. Press the button [ PY ] or [ PB ] to increase or reduce the programme number by 1 at a time or select
. each programme number directly with the numeric buttons on the remote control.
TELETEXT
Your display can receive and display TOP/FLOF teletext information.
. Select a television channel with teletext.
. Press the button [TEXT] on the remote control to display teletext
or
. use the numeric buttons for direct selection of teletext pages.
The red, green, yellow and blue buttons on the remote control have different functions depending on the type of teletext,
these being displayed in the lower area of the teletext.
5.5

PC mode

. Switch off the display and the PC.
. Connect your PC and the display by means of the enclosed video cable (DVI plug on the display and HD-sub
connector on the PC).
. Switch ON the display and PC again.
PC (RGB) must be set in the menu option <INPUTS / PIP ' SOURCE>. Upon switching on, the display automatically
detects the picture format set on the PC. This information is displayed in an info window.
PC (RGB)
1024 x 768
5.6

Operation with additional devices

VIDEO RECORDER
. Switch OFF the display and video recorder.
There are 3 possibilities for connecting your video recorder to the display:
D via the aerial lead, read the operating instructions for the video recorder on this subject
D by means of a scart cable either to SCART1 or SCART2
D if your video recorder has an S-video output, connect this to the Y/C input.
. Switch the display and video recorder back ON.
. To switch over to the connected input (e.g. SCART1) press the [VIDEO] button repeatedly.
SCART 1
Full picture
DVD PLAYER
. Switch OFF the display and DVD player.
. Connect your DVD player by means of SCART1, YC input or YUV input, if it has an S-video output.
. Switch the display and DVD player back ON.
. To switch over the connected input, press the [VIDEO] button repeatedly.
YC
Full picture
5.7

Special functions

MANUAL CHANNEL SEARCH
. Against the menu option <PROGRAMM> enter a programme number that is not yet in use.
. Under the menu option <FREQUENCY> you must enter directly the frequency of the TV channel you are seeking
by means of the numeric buttons on the remote control.
. If the picture is not optimal, in small increments increase or reduce the frequency entered.
ENGLISH
19