Medion Pure Retro Mode D'emploi page 35

. Remove the two top polystyrene packing corners and take the accessories carton out of the packing. The latter is
located on the side at the rear of the display.
Opening edge
TOP
INSTALLATION
D Two persons are required to remove the plasma display from the packing. Never lift up the
display alone. An attempt to lift the display alone will present a risk to your health.
D Place the table stand on a stable and horizontal base. The substrate must be firm and ca-
pable of bearing the load.
D Before installation make sure that the display is switched off and that the mains cable and
signal cable are unplugged.
WALL MOUNTING
ENGLISH
Polystyrene corner
Wall bracket
Screw
Polystyrene corner
9