Osd Menu Operator Control - Medion Pure Retro Mode D'emploi

PREPARATIONS
. Open the battery compartment on the rear side of the remote control and insert the two batteries provided
(type LR03 micro AAA). Pay attention to the polarity as specified on the bottom of the battery compartment.
Close the battery compartment again.
TO SWITCH ON
. Switch the mains switch on the rear side of the display to position "I". The display is now in standby mode and can
be switched on by means of the remote control.
D Cable connection / terrestrial aerial
D Satellite receiver
D PC
4.3

OSD menu Operator Control

PERFORMING SETTINGS
Your display can be set and operated with the aid of the simple OSD menu control. 6 buttons are at your disposal on the
remote control for this purpose:
1
1
P Y button
Upward movement in the OSD menu. The selected menu or selected function appears against a
white background.
2
A button
To quit the selected function.
To quit a submenu select menu option < ← > and press the button [ A ].
Change the setting in the selected menu option.
3
M button
Saves any changes that have been performed.
4
MENU button
Displays the OSD main menu. The main menu appears on the top left edge of the display. Exit OSD menu.
ENGLISH
. Switch on the display by means of the TV button on your remote
control.
. Switch on your satellite receiver and switch on the display via the but-
ton [VIDEO] on your remote control. Please take note that you may
have to press the button [VIDEO] several times depending on which
SCART socket your receiver is connected to.
. Switch on the display with the button [PC] on your remote control and
select the appropriate signal input ( PC(RGB) or PC(DVI) ). To do so
call up your display's OSD menu via the remote control button [MENU]
and select your input signal in the submenu <INPUTS>.
2 3 4 5 6
11