Tools Required; Control Box Installation; Adjustment Of The Lever Inclination - Ultraflex B 301 Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Tools required

Phillips
screwdriver

3.2 Control box installation

1 Install the control in a position that allows the lever to rotate free and take care that it can reach the
full forward and full reverse stroke.
2 Refer to the overall dimensions given in paragraph 1.2 to check that the box can effectively be
installed in the desired position.
WARNING
When the cable is installed avoid too narrow bends.
3 After determining the appropriate location, drill the holes required to assemble the control box
using the template provided for single or dual control.
For the single and dual control installation refer to the drilling templates enclosed.
NOTICE
Connect the cables to the lever before the lever control to the dashboard.
CAUTION
The use of a proper killing switch system is recommended for each ULTRAFLEX control system installation.

3.3 Adjustment of the lever inclination

The lever angular position can be adjusted both forward and backward according to the control position.
Follow the instructions below:
1 Remove the rubber
cover from the lever
hub (1).
3 Take out the
hexagonal head screw
(3) with a 17 socket
wrench.
page 8
of 47 -
SINGLE LEVER CONTROL B301 AND B302
Pliers
2 Extract the plastic
pin (2).
1
4 Extract the lever
and turn it to the
desired position, then
reinsert it by putting
3 into gear with the
shaft of the control
box.
Installation and maintenance manual
Open end
wrench
8mm [0,31"]
Socket wrench
17mm [0,66"]
2