Ordinary Maintenance; Specialmaintenance; Technical Assistance; Dismantling - Ultraflex B 301 Manuel D'installation Et D'entretien

ULTRAFLEX
6 MAINTENANCE

6.1 Ordinary maintenance

WARNING
Failure to apply maintenance controls may result in loss of control when driving, which can result in damage
to property and/or injury.
Maintenance requirements will vary depending on climate and frequency and type of use. Inspections must
be conducted at least every two years by an experienced nautical mechanic.
Perform the following maintenance operations:
- Periodically wash components with fresh water and remove any salt deposits
- Once a month, check all nuts holding the system in place and tighten if necessary.
DANGER
Loosening or separation of nuts holding the system in place can cause not only malfunctioning
of the single lever control but damage or injury.
- Periodically check the absence of corrosion on the metal parts of the cable terminals and of abrasions on
the sheath.
- Replace damaged parts that may compromise the integrity of the single lever control.

6.2 Specialmaintenance

For any information or assistance with particular applications please contact our technical assistance

7 DISMANTLING

7.1 Dismantling
If you intend not to use the single lever control system any more, dispose of it in an environmentally sound
way.
Sheaths, hoses and components made of plastic or other non-metallic materials must be dismantled and
disposed of separately.

Technical Assistance

service (See paragraph "Introduction").
SINGLE LEVER CONTROL B301 AND B302
Installation and maintenance manual
page 15
- of 47