Throttle Cable Connection - Ultraflex B 301 Manuel D'installation Et D'entretien

ULTRAFLEX
7 Engage the rod
(13) on the pin (I)
I
WARNING
Check the right setting of shift cable stroke and make sure that is compliant with the following conditions.
During the shift engagement, the lever movement must be always fluid with a constant resistance.
The lever must no become stiffer during the throttle engagement, otherwise check that the control shift
stroke corresponds to the engine one.

3.5.2 Throttle cable connection

1 Remove the cable fastener (7) from the plate
(8) removing the screws (9).
9
3 Engage the rod (16) on the pin (17).
5 Fix the cable inserting the circlip (E) in the
groove of the pin (17).
13
8
(H) in the way shown
in the picture and fix
it with the screw (G)
on the hole (14).
2
cylinder (10) is placed inside the plate hole (15).
8
7
4
fastener (7) on the plate
(8) aligning the cable
cylinder (10) with the
16
hole of the cable
fastener.
Fix the cable fastener
to the plate with the
17
screws (9).
For
throttle, connect the
cable rod on the pin
E
(17A) and insert the
cable cylinder into
17
the plate hole (15A).
SINGLE LEVER CONTROL B301 AND B302
Installation and maintenance manual
Mount the plate
14
Mount the cable making sure the cable
10
15
Remount the cable
10
9
NOTICE
17A
push action
G H
8
7
15A
page 11
- of 47