Lever Use; Safety Warnings; Clothing - Ultraflex B 301 Manuel D'installation Et D'entretien

ULTRAFLEX
4 USE

4.1 Lever use

The lever stroke is made up of two movements:
operating the shift in the first 30° and the throttle in
the rest of the stroke.
The boat moves forward when the lever is in forward
position, and it moves backward when the lever is put
in reverse position. To unlock the throttle without
engaging a gear press the button located on the lower
part of the lever and at the same time put the lever
forward.
DANGER
Before starting the engine, if the control is not provided with safety switch, make sure that the lever is in
neutral position.

5 SAFETY WARNINGS

This section illustrates the safety regulations to be applied for proper use of the apparatus.
Read this section very carefully and also read the manuals supplied with other components of the single
lever control.
5.1 Safety warnings during installation and use
OBLIGATORY FOLLOW the precautions and safety criteria indicated below.
ULTRAFLEX shall not be held liable for the user's failure to observe these precautions and criteria and shall
not be held liable for any negligence in use of the system.
DANGER
- NEVER PUT HANDS BETWEEN THE MOVING PARTS.
- Do not deactivate safety devices or render them inoperative.
- Do not modify the system or add devices to it without written authorization or the intervention of an
ULTRAFLEX technician describing the change made in the description of the work performed.
- Do not use the apparatus for any purpose other than its intended purpose as specified in the installation
and maintenance manual.
- Do not allow untrained personnel to perform installation.
WARNING
- During installation of the system, take particular care to keep everything clean to ensure that no
foreign bodies can get into the system. Even a tiny object can cause permanent damage which may
not be immediately obvious.
- Avoid cable curve radiuses of < 200 mm (8").
- Do not let cables come into contact with sharp corners or edges.
- Do not let cables come into contact with heat sources.

5.2 Clothing

WARNING
DO NOT wear necklaces, bracelets or any loose garments that could get caught in moving parts during
ATTENZIONE
installation, inspection or maintenance work.
page 14
of 47 -
SINGLE LEVER CONTROL B301 AND B302
ATTENZIONE
Installation and maintenance manual
SHIFT ENABLING
T H R O T T L E
ENABLING
!