Troubleshooting - Bemer Classic-Set Mode D'emploi

Troubleshooting

General information
BEMER products are equipped with intelligent electronics.
They can therefore automatically detect and display errors.
Should an error be displayed or should you suspect malfunc-
tion, check the following:
•
Is the power supply connected to the outlet correctly (does
the power supply have a corresponding control light)? If not,
connect the power supply to the outlet.
•
Is the power supply connected to the B.BOX correctly?
If not, connect the power supply to the B.BOX.
•
Are the desired applicator modules properly connected?
•
Are all relevant cables and plugs undamaged?
62
If an error still persists or has not been properly located, please
follow the instructions for the corresponding error code or con-
tact your responsible service address. When in doubt, you can
obtain information at www.bemergroup.com, where you will
find your closest contact person.
Switching off the error message
When the error or cause has been remedied, you can switch
off the error message on the product. This procedure using the
B.BOX Pro is self-explanatory and can be found in the navigation
menu. The error message on the B.BOX Classic can be shut off
by pressing the "Set" button.
ERROR MESSAGE CAUSE
ERROR 1 An active applicator has been removed during the
application.
ERROR 2 The temperature of the product is too high.
ERROR 3-4 There is a problem with the applicator module.
ERROR 5-6 There is a malfunction of the power supply.
ERROR 7-8 There is a malfunction of the control unit.
ERROR 9-12 There is a malfunction of the applicator module.
ERROR 101 There is no applicator connected.
ERROR 104 An unknown applicator has been detected.
ERROR 105 The capacity of the battery is too low.
ERROR 108 Chipcard cannot be read properly.
For error messages that are not described here, please contact service.
fr es en

TROUBLESHOOTING

Reconnect the applicator and start the application again.
Check the environmental conditions and let the product
cool down. When in doubt, contact service.
Please contact service.
Please check for the possible sources of error such as:
the power supply, the vehicle connection cable (12 volt)
or the rechargeable battery (see technical data). When in
doubt, contact service.
Please contact service.
Please contact service.
Please connect an applicator to the product.
The applicator module is invalid; please contact service.
The battery is empty; recharge the battery by connecting
to the power supply.
Please contact service.
63